Installation of colored led tapes, with or without remote control, in various situations of use are shown here. RGB led tape installation with remote control will be done without any problems if you have all you’ll need: a colored led tape roll (1), a power supply (2) and a remote control controller (3). First, connect the controller and tape connectors to the polarity – depending on the raised signal highlighted below (1). Then, plug the power supply into the controller (2). And that’s all. The installed kit will give the light!

Remote control for RGB led tape – The most common model is optical, so there is a led on the top (1) of the remote control that needs to be pointed at the receiver on the controller – those two wires that end in a black box (1 ). Make sure that this receiver is not concealed on the plaster or hidden behind the panel, otherwise the remote control will not work. It may seem obvious, but anxiety often leads people to try to use the remote without removing the battery protective seal (2). Remember to remove the seal first. For more types, try the link bellow.
Source.

...